My T600 is dead

[pabm00]

I try to make an upgrade, nothing to do, no bootloader charged. After that the T600 seems like dead. When I turn on the device I see the splash screen with the logo and, after that, the device reboot in continue. Help me, what can I do?

[dattad]

Did you flash your device before? Do you press the right buttons for an upgrade? As I understand your device shows the logo and reboots? Or it loads normally?

[pabm00]

Did you flash your device before? Do you press the right buttons for an upgrade? As I understand your device shows the logo and reboots? Or it loads normally?

I've flashed the device 2 times before, and i have press the right buttons with right firmware to upgrade according to the language of the device. Gsmart now shows the splashscreen and, after few seconds, reboot. This in continuous. Nothing to do with the key's sequence for calling bootloader or hard reset. Thanks in advice.

[dattad]

Once I had the same situation. I had to replace the motherborad, only this helped.

[VitekS]

Hi,
i have same problem.Have T600 Engineering Mode or Boot Config?

[dattad]

yes, it has: http://www.gsmartclub.com/eng/faq8.htm

[VitekS]

Thx,
but Engineering Mode not start.I looking for new motherboard, must buy new, but where i'm from Czech Republic

[dattad]

I know that you can buy it in the official service centers only, maybe it would be more simple to send the device to them and they'll do everything, especially if you have a not expired warranty.

[seyyah]

hallo my phone t600 no starting after flahsing ,no enginer mode can you suppert centre adresses in germany ,i have no warranty regards

[dattad]

Have you tried to flash it again?
You can contact Gigabyte directly and ask them about service: http://ggts.gigabyte.com.tw/MobileSupportForm.asp