Site Announcements

Be the first to get the news! Use Forum's RSS Feed!
Start!


Breaked screen.

Share/Save/Bookmark

This is where to post general questions, discuss your device features, functions and settings.

Breaked screen.

Postby mariom » Mon Mar 29, 2010 6:49 pm

Is it possible to change screen on warranty, isn't it?

If not, how much cost screen for mw700?
mariom
 
Posts: 13
Joined: 02 Dec 2009
Phone: GSmart MW700

Re: Breaked screen.

Postby dattad » Mon Mar 29, 2010 9:16 pm

If it's not damaged by you, then it's covered by warranty.
Please consider a small donation to GSmart Club!
I don't answer PMs regarding GSmart, use the forum for your questions.
User avatar
dattad
Admin
 
Posts: 1333
Joined: 28 Mar 2008
Location: Russia
Phone: GSmart t600

Re: Breaked screen.

Postby mariom » Tue Mar 30, 2010 8:26 pm

Screen is cracked and i have on screen black spillage. It happend in my pocket. Don't you know the cost of screen?
mariom
 
Posts: 13
Joined: 02 Dec 2009
Phone: GSmart MW700

Re: Breaked screen.

Postby dattad » Tue Mar 30, 2010 9:38 pm

No, I don't.
Please consider a small donation to GSmart Club!
I don't answer PMs regarding GSmart, use the forum for your questions.
User avatar
dattad
Admin
 
Posts: 1333
Joined: 28 Mar 2008
Location: Russia
Phone: GSmart t600

Re: Breaked screen.

Postby 2234jones » Fri Apr 16, 2010 11:29 am

Hi there, I'm having to replace mine, and follow this link on ebay, some will even send you instructions, hope this helps
http://cgi.ebay.com.au/OEM-LCD-Screen-D ... 1540wt_941
thanks Mark
2234jones
 
Posts: 7
Joined: 16 Apr 2010
Phone: GSmart MW700

Re: Breaked screen.

Postby 2234jones » Fri Apr 30, 2010 1:50 pm

Just an update, I have replaced my complete LCD and it was the easiest phone I have done.

1. Remove the battery and sim card, and Memory card, and battery. Carefully run your finger nail around the top of the phone where the camera is and as you do you will hear clicks, and it slowly comes apart, do not force.

2. There are five screws, remember where they go as the bottom left corner one is longer than the rest. There are four philips screws on the edge, and then a small chrome one near to the camera lense.

3. remove these screws, and again with your nail, slowly run it around the front panel, and the silver middle piece of plastic, you should hear it click as you run around the edge. Remove the front panel from the board, which is held by 3 plastic clips.

4. Do not pull it too much, as the button pad is attached to the front panel, jump lay it to one side. The screen, then folds to the left side, and you will see its ribbon attached to the board at the bottom left of the screen. Carefully release the clip and slide the ribbon out.

5. Place the new screen ribbon onto the clip and push into place ensuring its home.

6. Close the locking clip and then lay the screen onto the main board.

7. place the front panel onto the board and clip it on. Then clip the middle piece together.

8. Put the screws back into the holes they came from and then clip the top rear cover on.

9. place the battery back in and then once the cover is back on, then power it up.
2234jones
 
Posts: 7
Joined: 16 Apr 2010
Phone: GSmart MW700


Return to GSmart MW700, MS800 discussion

Who is online

Users browsing this forum: No registered users and 2 guests